A Pak Paving Resurfaces Our Asphalt Driveway

Best Comment so far (description follows): I recently watched you re video about the installation and sealcoating of you re asphalt driveway. Just thought I d reach out to you with some friendly input. I ve been in the asphalt pavement business for over 10 years so I ve got a bit of knowledge. Firstly the reason the asphalt is so coarse is because it appears to be a material referred to as 3TS. A lot of contractors will use this mix because it saves them money. Normally for a new driveway installation or a dig out and repave you would start with a compacted and finely graded stone base and then you would use an asphalt binder for the initial base on top of the stone. The binder is an asphalt comprised of larger stones and ends up being extremely coarse, this layer should be applied at a minimum of 2. After the binder is laid and compacted with a roller then the final layer of extremely fine asphalt should be applied on top of it at 1 1, 2 to 2 and then rolled again.